HI-6000 - HI-6001
Installation Instructions

	Home
	Company
	Products
	Where to Buy
	Bidet Installation
	Bidet Operation
	Customer Bidet Support
	Bidet Registration

Getting Started (Read all instructions before you begin) (Click Graphics to Enlarge)	Follow these steps: If you lack electrical or plumbing experience you should have a professional install the bidet. Unpack the bidet Tools Required: Pliers, Wrench, and Straight Slot Screwdriver Caution: The operational water pressure range required is between 10-100 Pound Per Square Inch (PSI). If the pressure is low the water stream pressure of the shower will be affected. Do not turn on the water or power until installation is complete.
	Step 1: Loosen the nuts on the mounting bolts and remove the toilet seat assembly.
	Step 2: First, insert black rectangular rubber pad under white slide plate (Base B). Next, place two bolts through Base B then through flat, grey rubber washer. Insert bolt into seat mounting hole and fasten with cone shaped grey rubber washer and nuts.
	Step 3: Push the bidet system onto slide plate following the arrow. When secure a click will sound.
	To Uninstall: push seat release button and slide off the bidet unit.
	Step 4: Shut off water supply valve (located at the bottom of the wall). Flush the toilet to empty water tank. Remove the water hose from the bottom of the water tank (Ball Cock).
	Step 5: Attach T connector (provided) to the bottom of the water tank. Teflon tape is not required for installation. Keep all connections aligned and do not over tighten, as this may damage connections.
	Step 6: Connect water hose to T connector (7/8" threaded side).
	Step 7: Connect Flexible water hose (provided) from T connector (1/2" threaded side) to system external water tank located under the control panel and open the water shutoff valve.
	Step 8 : Plug the main unit into a GFI 3 prong outlet.
	Bidet Overview Click Graphic for Instructions
	Main Body Operations Click Graphic for Instructions
	Remote Control Features Click Graphic for Instructions
	Remote Control Operations #1 Click Graphic for Instructions Remote Control Time Setting: Press the Off button for 5 seconds, until hour LED display starts blinking. Adjust the hour by using the Front Wash button to increase and Back Wash to decrease. Press OFF button once more so minute LED is flashing. Adjust time with Front Wash button increasing time and the4 Back Wash decreasing time. After time is set, touch any other button once to complete time set. Clock will also set if you do not touch any buttons for 5 seconds.
	Remote Control Operations #2 Click Graphic for Instructions Notice: When Low Battery appears on teh LED display, it is time to change the battery. After changing the battery, you will need to reset your personal settings. Insure that nothing is covering the transmitters.
	Operation Warning Notice Click Graphic for Instructions

HI-6000 - HI-6001 Installation Instructions

HI-6000 - HI-6001
Installation Instructions