HI-1000 - HI-1001
Installation Instructions

Getting Started (Read all instructions before you begin) (Click Graphics to Enlarge)	Follow these steps: If you lack electrical or plumbing experience you should have a professional install the bidet. Unpack the bidet Tools Required: Pliers, Wrench, and Straight Slot Screwdriver Caution: The operational water pressure range required is between 10-100 Pound Per Square Inch (PSI). If the pressure is low the water stream pressure of the shower will be affected. Do not turn on the water or power until installation is complete.
	Step 1: Loosen the nuts on the mounting bolts and remove the toilet seat assembly.
	Step 2: First, insert black rectangular rubber pad under white slide plate (Base B). Next, place two bolts through Base B then through flat, grey rubber washer. Insert bolt into seat mounting hole and fasten with cone shaped grey rubber washer and nuts.
	Step 3: Push the bidet system onto slide plate following the arrow. When secure a click will sound.
	To Uninstall: push seat release button and slide off the bidet unit.
	Step 4: Shut off water supply valve (located at the bottom of the wall). Flush the toilet to empty water tank. Remove the water hose from the bottom of the water tank (Ball Cock).
	Step 5: Attach T connector (provided) to the bottom of the water tank. Teflon tape is not required for installation. Keep all connections aligned and do not over tighten, as this may damage connections.
	Step 6: Connect water hose to T connector (7/8" threaded side).
	Step 7: Connect Flexible water hose (provided) from T connector (1/2" threaded side) to system external water tank located under the control panel.
Operations	After you have completed the above steps it is time to test the operation of the bidet.

• Sit to the back of the toilet seat then adjust body position while spray is on.
• Slowly turn the “Back Wash” knob clockwise to turn on the back wash or blue nozzle.
• Turn the “Back Wash” knob counter clockwise to turn off the “Back Wash” spray.
• Slowly turn the “Front Wash” knob clockwise to turn on the front wash or pink nozzle.
• Turn the “Front Wash” knob counter clockwise to turn off the “Front Wash” spray.
• Be sure that both knobs are turned completely counterclockwise (off) before standing.

Home | Contact Us | Privacy Policy | Legal | Copyright | Sitemap