|
Getting Started
(Read all instructions before you
begin)
(Click Graphics to Enlarge) |
Follow these steps:
- If you lack electrical or plumbing experience
you should have a professional install the bidet.
- Unpack the bidet
- Tools Required: Pliers, Wrench, and Straight
Slot Screwdriver
Caution:
- The operational water pressure range required is
between 12-100 Pound Per Square Inch (PSI). If the
pressure is low the water stream pressure of the
shower will be affected.
- Do not turn on the water or power until
installation is complete.
|
 |
Step 1: Loosen the nuts on the
mounting bolts and remove the toilet seat assembly. |
 |
Step 2: First, insert black
rectangular rubber pad under white slide plate (Base
B). Next, place two bolts through Base B then through
flat, grey rubber washer. Insert bolt into seat mounting
hole and fasten with cone shaped grey rubber washer and
nuts. |
 |
Step 3: Push the bidet system
onto slide plate following the arrow. When secure a
click will sound. |
 |
To Uninstall: push seat release button
and slide off the bidet unit. |
 |
Step 4: Shut off water supply
valve (located at the bottom of the wall). Flush the
toilet to empty water tank. Remove the water hose from
the bottom of the water tank (Ball Cock). |
 |
Step 5: Attach T connector
(provided) to the bottom of the water tank. Teflon tape
is not required for installation. Keep all connections
aligned and do not over tighten, as this may damage
connections. |
 |
Step 6: Connect water hose to T
connector (7/8" threaded side). |
 |
Step 7: Connect Flexible water
hose (provided) from T connector (1/2" threaded side) to
system external water tank located under the control
panel and open the water shutoff valve. |
 |
Step 8 : Plug the main unit into a GFI 3 prong
outlet.
|
 |
Bidet Overview
Click Graphic for Instructions |
 |
Main Body Operations
Click Graphic for Instructions |
 |
Remote Control Features
Click Graphic for Instructions |
 |
Remote Control Operations #1
Click Graphic for Instructions
Remote Control Time Setting:
-
Press the Off button for 5 seconds,
until hour LED display starts blinking.
-
Adjust the hour by using the Front
Wash button to increase and Back Wash to decrease.
-
Press OFF button once more so minute
LED is flashing. Adjust time with Front Wash button
increasing time and the4 Back Wash decreasing time.
-
After time is set, touch any other
button once to complete time set. Clock will also
set if you do not touch any buttons for 5 seconds.
|
 |
Remote Control Operations #2
Click Graphic for Instructions
Notice:
-
When Low Battery appears on teh LED
display, it is time to change the battery. After
changing the battery, you will need to reset your
personal settings.
-
Insure that nothing is covering the
transmitters.
|
 |
Operation Warning Notice
Click Graphic for Instructions |
