If you lack electrical or plumbing experience
you should have a professional install the bidet.
Unpack the bidet
Tools Required: Pliers, Wrench, and Straight
Slot Screwdriver
Caution:
The operational water pressure range required is
between 12-100 Pound Per Square Inch (PSI). If the
pressure is low the water stream pressure of the
shower will be affected.
Do not turn on the water or power until
installation is complete.
Step 1: Loosen the nuts on the
mounting bolts and remove the toilet seat assembly.
Step 2: First, insert black
rectangular rubber pad under white slide plate (Base
B). Next, place two bolts through Base B then through
flat, grey rubber washer. Insert bolt into seat mounting
hole and fasten with cone shaped grey rubber washer and
nuts.
Step 3: Push the bidet system
onto slide plate following the arrow. When secure a
click will sound.
To Uninstall: push seat release button
and slide off the bidet unit.
Step 4: Shut off water supply
valve (located at the bottom of the wall). Flush the
toilet to empty water tank. Remove the water hose from
the bottom of the water tank (Ball Cock).
Step 5: Attach T connector
(provided) to the bottom of the water tank. Teflon tape
is not required for installation. Keep all connections
aligned and do not over tighten, as this may damage
connections.
Step 6: Connect water hose to T
connector (7/8" threaded side).
Step 7: Connect Flexible water
hose (provided) from T connector (1/2" threaded side) to
system external water tank located under the control
panel.
Trial
Operations
After you have completed the above steps
it is time to test the operation of the bidet.
Completed Installation
Note:
The Bidet System will automatically shut off after 5
minutes of use. Press "Bidet On", "Wash On", or "Dryer"
button to continue use.
1. Action:
Open on the shutoff valve and check for water
leaks.
Control Panel lights will turn on when system is
plugged in.
2. Action:
Maintain pressure near the junction of the lid
and seat to operate the following trial.
Trail Operation
Click the graphic to review the testing
procedure.
Open the water shut off valve and plug in unit.
Press the "{Wash" or "Bidet" button while
pressing down right side of the seat for about 45
seconds.
Water has filled lines and tank when the nozzle
start to extend.
The dryer function will stop automatically after
5 minutes.
